Hey everyone welcome to another DIY post.
I wanted to do a quick one today as my last one was very chatty! I've seen a few people do these on YouTube but you can actually make your own paper bow from DSP and it looks amazing.
It's very quick and easy to do and you can create a bow to match any wrapping paper you would like.
If you want to find out how to make it then just keep reading.
Steps:
1) You will need to cut 13 pieces of double sided DSP. One will be 1" x 4", four will be 1" x 5", and the final eight will be 1" x 6"
2) Have four of the longer piece the other sides up to show a different pattern from the rest. Place a small amount of sticky strip on one of the shorter sides
3) With the smaller piece fold it round to a circle and secure. Then with the rest fold the other short end over the sticky strip and twist slightly. Make sure you keep them grouped together by size. See picture below for reference
4) Pierce a small hole in the bottom and attach the four different groups together
5) To build adhere with a glue gun or glue dots the two biggest sizes and twist the top on so its off centre. Then add the small group again twisting and finally add the single circle to the centre!
There you have it! It's so simple to do and you could make up plenty is so long.
I really hope you enjoyed this post! If you have any questions please be sure to leave them down below.
Happy crafting!
Susan x
No comments:
Post a Comment